Netgear WNDAP380Rv2 Instrukcja Użytkownika Pobierz pdf (Strona 62)

Wireless Configuration and Security

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

3. Enable or disable the WMM features:

• Enable Wi-Fi Multimedia (WMM)

. To enable this feature, select the Enable radio

button.

By default, this feature is enabled. Select the Disable radio button to disable the

feature.

• WMM Powersave. To enable this feature, select the Enable radio button, which is the

default setting.

By default, this feature is enabled. Select the Disable radio button to disable the

feature.

4. Click Apply.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 151 152

ProSAFE Dual Band Wireless-N 1
WNDAP380R 1
Trademarks 2
Revision History 2
Contents 3
Chapter 4 Management 4
Chapter 6 Monitoring 4
Chapter 7 Troubleshooting 5
What Is in the Box? 7
System Requirements 8
Key Features and Standards 8
Key Features 9
Networking 10
Hardware Description 11
Rear Panel 12
Introduction 13
Installation and Basic 14
Configuration 14
Ethernet Cabling Requirements 16
Web Management Interface 19
 To configure time settings: 20
Configure the IP Settings 21
Ceiling Installation 31
Wall Installation 35
Desk Installation 38
Wireless Configuration and 39
Security 39
Security Profiles 42
Security Profile Concepts 43
Form for 802.11b/bg/ng Modes 44
Form for 802.11a/an Modes 45
Configure Legacy 802.1X 52
Figure 11. Legacy 802.1X 53
Figure 12. WPA with RADIUS 53
Figure 13. WPA2 with RADIUS 53
Figure 15. WPA-PSK 54
Figure 16. WPA2-PSK 54
Management 63
Enable Remote Management 64
Web Browser Upgrade Procedure 67
TFTP Server Upgrade Procedure 68
Defaults 69
Restore the Configuration 70
Settings 70
Default Configuration 72
Enable the Syslog Server 73
 To enable a syslog server: 74
 To configure STP and VLANs: 80
Configure Hotspot Settings 81
 To set up a hotspot server: 82
 To configure advanced QoS: 86
4. Click Apply 87
Configure Wireless Bridging 88
Advanced Configuration 100
Configure RFID Settings 103
 To reboot the RFID module: 106
 To reset the RFID module: 106
3. Click Apply 107
Monitoring 108
View System Information 109
Monitor Wireless Clients 111
View the Activity Log 113
Traffic Statistics 114
Troubleshooting 116
Basic Functioning 117
Wireless-Capable Computer 118
 Check these items: 119
Request timed out 121
Problems with Date and Time 122
Troubleshoot the RFID Module 122
Supplemental Information 124
Technical Specifications 125
Factory Default Settings 127
Command-Line Reference 131
Numerics 147

Komentarze do niniejszej Instrukcji

Brak uwag

Netgear WNDAP380Rv2 Instrukcja Użytkownika Strona 62

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Punkty dostępu do sieci WLAN Netgear WNDAP380Rv2