Netgear XSM7224S Instrukcja Użytkownika Pobierz pdf (Strona 13)

100

101

1-1

v1.0, November 2010

Chapter 1

Using the Command-Line Interface

The command-line interface (CLI) is a text-based way to manage and monitor the system. You can

access the CLI by using a direct serial connection or by using a remote logical connection with

telnet or SSH.

This chapter describes the CLI syntax, conventions, and modes. It contains the following sections:

• “Command Syntax” on page 1-1

• “Command Conventions” on page 1-2

• “Common Parameter Values” on page 1-3

• “Unit/Slot/Port Naming Convention” on page 1-3

• “Using the “No” Form of a Command” on page 1-4

• “Managed Switch Modules” on page 1-5

• “Command Modes” on page 1-5

• “Command Completion and Abbreviation” on page 1-9

• “CLI Error Messages” on page 1-9

• “CLI Line-Editing Conventions” on page 1-10

• “Using CLI Help” on page 1-11

• “Accessing the CLI” on page 1-12

Command Syntax

A command is one or more words that might be followed by one or more parameters. Parameters

can be required or optional values.

Some commands, such as show network or clear vlan, do not require parameters. Other

commands, such as network parms, require that you supply a value after the command. You

must type the parameter values in a specific order, and optional parameters follow required

parameters. The following example describes the network parms command syntax:

Format network parms <ipaddr> <netmask> [gateway]

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 578 579

Komentarze do niniejszej Instrukcji

Brak uwag

Netgear XSM7224S Instrukcja Użytkownika Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Netgear XSM7224S